Introduction In the previous article, Part 1 of this CTF, we were able to complete the following steps on the victim machine: Getting the target machine IP address by running the VM Getting open port details by using the Nmap tool Enumerating HTTP port 80 service with Dirb utility Enumerating HTTP port 8000 and 8080 […]

The post Typo 1: VulnHub CTF walkthrough (part 2) appeared first on Infosec Resources.


Typo 1: VulnHub CTF walkthrough (part 2) was first posted on October 22, 2020 at 8:06 am.
©2017 “InfoSec Resources“. Use of this feed is for personal non-commercial use only. If you are not reading this article in your feed reader, then the site is guilty of copyright infringement. Please contact me at darren.dalasta@infosecinstitute.com

By admin